![]() ![]() ![]() "If using BeagleBone Black and the image is meant to program your on-board eMMC, you’ll need to wait while the programming occurs. ![]() There is booting off internal NAND which only has 70mb (or is this only a partition Only when I take out the SD card the BBB boots into the original installation.ĭoes anyone know what may have caused this? This is a brand new SD card, and I doubt I had damaged it by resetting the BBB.Īs far as I understand there are 3 booting options, I tried resetting and holding down the button again, but it would not boot off the SD card. I scanned all ports and it was not available. Next, I tried hitting the reset button to see if it will boot off the SD card again, nothing happened and I could not connect to the BBB any more. Initially I powered on by holding the button next to SD card, It booted and I could tell it was not the internal image, because it did not have the demo applications. Here’s what happened, I installed a 4GB image from getting started section onto my SD card ![]() I don’t understand how to determine whether the BBB is booting off the SD card or booting off the internal flash. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |